BEC 6300VNL Manuel d'utilisateur télécharger pdf (Page 51)

Device Configuration /

Interface Setup

BEC 6300VNL User Manual

Status: Select whether to enable the service.

IPv4/IPv6

IP Version: Choose IPv4, IPv4/IPv6, IPv6 based on your environment. If you don’t know which one to

choose from, please choose IPv4/IPv6 instead.

ISP Connection Type:

ISP: Select the encapsulation type your ISP uses.

 Dynamic IP: Select this option if your ISP provides you an IP address automatically.

 Static IP: Select this option to set static IP information. You will need to enter in the Connection

type, IP address, subnet mask, and gateway address, provided to you by your ISP. Each IP

address entered in the fields must be in the appropriate IP form. IP address from by four IP

octets separated by a dot (xx.xx.xx.xx). The Router will not accept the IP address if it is not in

this format.

 PPPoE: Select this option if your ISP requires you to use a PPPoE connection.

 Bridge: Select this mode if you want to use this device as an OSI Layer 2 device like a switch.

802.1q Options

802.1q: When activated, please enter a VLAN ID.

VLAN ID: It is a parameter to specify the VLAN which the frame belongs. Enter the VLAN ID

identification, tagged: 0-4095.

PPPoE (If selected PPPoE as WAN Connection Type; otherwise, skip this part)

Username: Enter the user name provided by your ISP.

Password: Enter the password provided by your ISP.

Bridge Interface for PPPoE: When “Activated”, the device will gain WAN IP from your ISP with the

PPPoE account. But if your PC is connected to the router working as a DHCP client, in this mode, the

device acts as a NAT router; while if you dial up with the account within your PC, the device will then

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 121 122

Pas de commentaire

BEC 6300VNL Manuel d'utilisateur Page 51