BEC 6300VNL Manuel d'utilisateur télécharger pdf (Page 52)

Device Configuration /

Interface Setup

BEC 6300VNL User Manual

work as a bridge forwarding the PPPoE information to the PPPoE server and send the response to

your PC, thus your PC gets a WAN IP working in the internet.

Connection Setting

Connection:

 Always On: Click on Always On to establish a PPPoE session during start up and to

automatically re-establish the PPPoE session when disconnected by the ISP.

 Connect Manually: Select Connect Manually when you don't want the connection up all the

time.

TCP MSS Option: Enter the maximum size of the data that TCP can send in a segment. Maximum

Segment Size (MSS).

IP Options

Default Route: Select Yes to use this interface as default route interface.

TCP MTU Option: Enter the maximum packet that can be transmitted. Default MTU is set to 1492.

IPv4 Options

Get IP Address: Choose Static or Dynamic

Static IP Address: If Static is selected in the above field, please enter the specific IP address you get

from ISP and the following IP subnet mask and gateway address.

IP Subnet Mask: The default is 0.0.0.0. User can change it to other such as 255.255.255.0.Type the

subnet mask assigned to you by your ISP (if given).

Gateway: Enter the specific gateway IP address you get from ISP.

NAT: Select Enable if you use this router to hold a group of PCs to get access to the internet.

Dynamic Route:

 RIP Version: (Routing Information protocol) Select this option to specify the RIP version,

including RIP-1, RIP-2.

 RIP Direction: Select this option to specify the RIP direction.

- None is for disabling the RIP function.

- Both means the router will periodically send routing information and accept routing

information then incorporate into routing table.

- IN only means the router will only accept but will not send RIP packet.

- OUT only means the router will only send but will not accept RIP packet.

TCP MTU Option: Maximum Transmission Unit, the maximum is 1500.

IGMP Proxy: IGMP (Internet Group Multicast Protocol) is a network-layer protocol used to establish

membership in a Multicast group. Choose whether enable IGMP proxy.

IPv6 options (only when choose IPv4/IPv6 or just IPv6 in IP version field above):

IPv6 Address: Type the WAN IPv6 address from your ISP.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 121 122

Pas de commentaire

BEC 6300VNL Manuel d'utilisateur Page 52