BEC 6200WZL Manuel d'utilisateur télécharger pdf (Page 70)

WAN Interface(Dual WAN)

Connect Mode: Select the Dual WAN from the drop-down menu.

Main WAN: Choose EWAN or 3G / 4G as main WAN. Click the link to go to WAN Profile page to

configure its parameters. Click the link beside it to configure the Main WAN connection. Turn to WAN

profile in the following part for help.

Backup WAN: Choose the left as backup WAN. Click the link to go to WAN Profile page to configure its

parameters. Click the link beside it to configure the backup WAN.

Connectivity Decision: Enter the value for the times when probing failed to switch backup port.

Failover Probe Cycle: Set the time duration for the Failover Probe Cycle to determine when the

router will switch to the backup connection (backup port) once the main connection (main port) fails.

Note: The time values entered in Failover Probe Cycle field is set for each probe cycle and

decided by Probe Cycle duration multiplied by Connection Decision value (e.g. 60 seconds are

multiplied by 12 seconds and 5 consecutive fails).

Failback Probe Cycle: Set the time for the Failback Probe Cycle.

Detect Rule (either one):

• Ping Gateway: It will send ping packet to gateway and wait response from gateway in every

“Probe

Cycle”.

• Ping Host: It will send ping packet to specific host and wait response in every “Probe Cycle”.

The host must be an IP address.

Click Apply to confirm the change.

This connection mode supports failover feature so that you can keep your WAN connection always on.

You should first configure the main and backup WAN connection profile.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 127 128

Pas de commentaire

BEC 6200WZL Manuel d'utilisateur Page 70